A welding table is easy to overlook when planning a workshop, yet a poor one undermines accuracy on every job that touches it. If the surface isn't flat, nothing clamped or squared against it will be either, and small errors compound quickly on anything with multiple joints or angles.
Keeping a stock of the right tungsten types, collets and gas lens sizes for the work you do avoids a lot of avoidable downtime, and it's the sort of consumables range worth sourcing from a specialist supplier like Tec Products UK.
Surface flatness and tolerance are the starting point, but fixturing is what turns a flat plate into a genuinely useful tool. Tables with a grid of holes or T-slots let you bolt down clamps, stops and jigs in repeatable positions, which speeds up repetitive fabrication and makes it far easier to hold parts square while tacking. A table without any fixturing options usually ends up needing extra clamps, magnets or improvised supports to achieve the same result.
Duty cycle is one of the most misunderstood figures on a welder's spec sheet, yet it tells you more about real-world usability than the headline amperage does. It's expressed as a percentage over a ten-minute period at a given output, so a machine rated at 30% duty cycle at its maximum amperage can run for three minutes out of every ten at that setting before it needs to rest and cool.
Helmet choice comes down to the mix of processes you run and how much you're prepared to spend for extra sensors or a wider shade range, and it's a straightforward conversation to have with a stockist that carries several options, including Tec Products UK.
Before choosing a machine, it's worth checking what your workshop's consumer unit and incoming supply can actually handle, not just what socket is nearest the bench. Buying a three-phase-only machine for a single-phase workshop, or underestimating the load a higher-output single-phase welder places on existing wiring, are both avoidable problems with a bit of checking upfront.