Looking After Your Visor: Cleaning And Replacement

A made to order helmet starts long before any material is cut. Measurements are taken, the intended use of the helmet is discussed, and a rider works with the maker to settle on a shell, lining and finish that suit them specifically, rather than picking from fixed stock sizes.

The trade off is scale. A workshop like this will never produce helmets as fast as a large factory, and that is treated as acceptable, since the aim is a considered, well finished helmet rather than the fastest one to market.

A helmet that is the right size should feel snug all the way round with no single pressure point, and it should not shift when you turn your head firmly from side to side. A helmet that moves independently of your head on a shake test is not the right fit, regardless of what the size label says.

ECE 22.06 is the current European standard that motorcycle helmets are tested against, and it replaced the older ECE 22.05 standard with a wider and more demanding set of tests. Helmets are checked for hedon London impact absorption at multiple points on the shell, not just the crown, and the standard also tests rotational forces, which earlier standards largely ignored.

A clean visor is a safety item as much as a comfort one, since scratches and haze scatter light and make it harder to judge distance in low sun or at night. Clean a visor with lukewarm water and a soft cloth, and avoid dry wiping, which is what causes most fine scratches in the first place.

A handcrafted helmet shell starts with a base material, commonly fibreglass or a composite blend, layered and shaped by hand rather than produced purely by mould and machine. Each layer adds strength, and the shaping stage is where a lot of the time in production actually goes.