Cutting capacity is usually described in terms of clean cut and maximum cut thickness, and the two are worth distinguishing. Clean cut is the thickness a machine handles with a good edge finish and reasonable speed, while maximum cut is the thickest material the machine will get through at all, usually slower and with a rougher edge. Buying with your typical material thickness in mind, rather than the thickest job you might occasionally face, generally gives a better day-to-day result.
Every workshop is different, so rather than relying on general advice, it's worth getting your own set-up properly assessed. A system that works well for one shop can be quite wrong for another with different ventilation, floor space or process mix, and an on-torch extraction option, such as those available for Fronius torches, suits a different layout to a fixed overhead hood.
A reliable, adequately sized compressed air supply is the part most first-time buyers underestimate. Undersized or contaminated air, whether from moisture, recent Inzicontrols blog post oil or an undersized compressor, is one of the most common causes of poor cut quality and shortened consumable life, so it's worth checking a machine's air requirements against what your compressor can actually deliver before you buy, not after.
Duty cycle is one of the most misunderstood figures on a welder's spec sheet, yet it tells you more about real-world usability than the headline amperage does. It's expressed as a percentage over a ten-minute period at a given output, so a machine rated at 30% duty cycle at its maximum amperage can run for three minutes out of every ten at that setting before it needs to rest and cool.
Flap discs sit between cutting and grinding in terms of use, combining overlapping abrasive flaps to blend welds, remove coatings and finish surfaces with more control than a solid grinding disc. Every disc also carries a maximum operating speed printed on it by the manufacturer, and checking this against your angle grinder's rated speed is a basic habit worth building into every new batch you open.
Where the extraction point sits relative to the arc makes a bigger difference than most people expect. A fixed overhead hood can miss fume entirely if the work moves around the shop, whereas a flexible arm or on-torch extraction follows the job and tends to capture more consistently. Filters also need regular checking and replacement; a clogged filter doesn't just reduce airflow, it can quietly reduce the whole system's effectiveness long before anyone notices.