A gas lens sits in place of the standard collet body and uses a fine mesh to straighten the shielding gas flow into a smoother, more laminar stream around the arc. This generally allows a longer stick-out from the cup without turbulence pulling in surrounding air, which is particularly useful when working in tighter joints or awkward positions where the torch needs to sit further back from the work.
Every workshop is different, so rather than relying on general advice, it's worth getting your own set-up properly assessed. A system that works well for one shop can be quite wrong for another with different ventilation, floor space or process mix, and an on-torch extraction option, such as those available for Fronius torches, suits a different layout to a fixed overhead hood.
A welding table is easy to overlook when planning a workshop, yet a poor one undermines accuracy on every job that touches it. If the surface isn't flat, nothing clamped or squared against it will be either, and small errors compound quickly on anything with multiple joints or angles.
Shade range and sensor count are the two specifications that matter most in daily use. A wider variable shade range lets one helmet cover a broader spread of processes and amperages, from low-amp TIG work through to higher-output MIG or MMA, without swapping cartridges. More sensors generally mean the filter is less likely to miss a low-angle arc or a strike caught at an awkward viewing angle, which matters most for TIG welding where the arc can be harder for a sensor to pick up cleanly.
Getting the right disc for the material and finish you're after saves both abrasives and time, and it's worth checking your current selection against the job list with a supplier who stocks a full abrasives range, such as plasma cutters.
Flap discs sit between cutting and grinding in terms of use, combining overlapping abrasive flaps to blend welds, remove coatings and finish surfaces with more control than a solid grinding disc. Every disc also carries a maximum operating speed printed on it by the manufacturer, and checking this against your angle grinder's rated speed is a basic habit worth building into every new batch you open.