MIG (metal inert gas) welding feeds a continuous wire electrode through a gun, shielded by a gas supply, which makes it fast and relatively forgiving for general fabrication, sheet steel and repair work. Jasic's MIG range is one of the more popular starting points here, covering entry-level compact units through to higher-output machines as work scales up. TIG (tungsten inert gas) uses a non-consumable tungsten electrode with a separate filler rod, giving a slower but tidier result that's favoured for thinner materials, aluminium and stainless steel where finish quality matters. MMA, or stick welding, strikes an arc from a flux-coated electrode and needs no shielding gas at all, which makes it the most portable option and a common choice for outdoor or on-site work on thicker steel.
Cutting capacity is usually described in terms of clean cut and maximum cut thickness, and the two are worth distinguishing. Clean cut is the thickness a machine handles with a good edge finish and reasonable speed, while maximum cut is the thickest material the machine will get through at all, usually slower and with a rougher edge. Buying with your typical material thickness in mind, rather than the thickest job you might occasionally face, generally gives a better day-to-day result.
Budget for a first machine is rarely just the welder itself. A gas cylinder and regulator for MIG or TIG, a decent auto-darkening helmet, gloves and basic workshop ventilation all add to the real cost of getting started, and skimping on the supporting equipment tends to cost more in frustration than it saves in cash. It's worth pricing the whole set-up before settling on a machine at the top of the budget.
Portability and power supply matter as much as the process itself. A stick welder will run from a generator or a domestic supply in places a gas bottle can't easily follow, while MIG and TIG set-ups need a gas cylinder and, for anything beyond light-gauge work, a heavier electrical supply. Workshop layout, the materials you weld most often, and how frequently the machine needs to travel are all worth weighing up before settling on one process.
Getting the right disc for the material and finish you're after saves both abrasives and time, and it's worth checking your current selection against the job list with a supplier who stocks a full abrasives range, such as welding supplies.
Plasma cutting uses a jet of ionised gas, usually compressed air, forced through a nozzle at high speed and heated by an electric arc to a temperature hot enough to melt through electrically conductive metal. The molten material is then blown clear by the same jet, leaving a narrow, clean cut. Unlike oxy-fuel cutting, plasma works on any conductive metal, including stainless steel and aluminium, not just carbon steel. Hypertherm is the plasma cutting brand we get asked about most, and it's worth understanding the basics before comparing specific units.