Where the extraction point sits relative to the arc makes a bigger difference than most people expect. A fixed overhead hood can miss fume entirely if the work moves around the shop, whereas a flexible arm or on-torch extraction follows the job and tends to capture more consistently. Filters also need regular checking and replacement; a clogged filter doesn't just reduce airflow, it can quietly reduce the whole system's effectiveness long before anyone notices.
Every workshop is different, so rather than relying on general advice, it's worth getting your own set-up properly assessed. A system that works well for one shop can be quite wrong for another with different ventilation, floor space or process mix, and an on-torch extraction option, such as those available for Fronius torches, suits a different layout to a fixed overhead hood.
Surface flatness and tolerance are the starting point, but fixturing is what turns a flat plate into a genuinely useful tool. Tables with a grid of holes or T-slots let you bolt down clamps, stops and jigs in repeatable positions, which speeds up repetitive fabrication and makes it far easier to hold parts square while tacking. A table without any fixturing options usually ends up needing extra clamps, magnets or improvised supports to achieve the same result.
The abrasive material itself matters as much as the shape. Discs formulated for steel typically contain aluminium oxide, while stainless steel usually calls for an inox-rated disc that's free from iron, sulphur and chlorine contaminants that could otherwise cause surface corrosion on the stainless. Aluminium and other soft, non-ferrous metals need their own dedicated abrasives too, since standard steel discs tend to clog quickly and produce a poor finish on softer materials.
The collet and collet body hold the tungsten in place and need to match its diameter exactly. A worn or incorrectly sized collet allows the tungsten to shift slightly during welding, which affects arc stability in ways that are easy to blame on technique when the actual cause is a consumable that needs replacing. CK Worldwide and Furick are two of the ranges we stock here, and these are inexpensive parts, but neglected ones cause a disproportionate amount of frustration at the torch.
Getting the right disc for the material and finish you're after saves both abrasives and time, and it's worth checking your current selection against the job list with a supplier who stocks a full abrasives range, such as www.tecproducts.co.uk.