The practical difference comes down to what a machine can draw and sustain. A single-phase supply has a ceiling on how much continuous power it can deliver before tripping breakers or overloading domestic wiring, which is why the highest-output welding and cutting equipment is frequently three-phase only, or offers noticeably better duty cycle performance when run on three-phase. For workshops without an existing three-phase supply, bringing one in usually means an electrician and, in some cases, an application to the local distribution network operator.
Buying a first welder is easy to overthink. Rather than starting from a shortlist of machines, it helps to start from the work: what materials, what thickness, and how much of it will be done indoors versus outside or on-site. That single question narrows the choice between MIG, TIG and MMA far more usefully than comparing spec sheets in isolation, whether you end up looking at a Jasic entry-level MIG package or something further up the range.
Cutting capacity is usually described in terms of clean cut and maximum cut thickness, and the two are worth distinguishing. Clean cut is the thickness a machine handles with a good edge finish and reasonable speed, while maximum cut is the thickest material the machine will get through at all, usually slower and with a rougher edge. Buying with your typical material thickness in mind, rather than the thickest job you might occasionally face, generally gives a better day-to-day result.
Abrasive discs look interchangeable on a shelf but perform very differently depending on what they're made from and what they're used on. Cutting discs are generally thin, designed to slice through material quickly with minimal heat build-up, while grinding discs are thicker and shaped to remove material from a surface or clean up a weld, rather than cut all the way through it.
Welding produces fume made up of fine particulates and gases, and the composition varies depending on the process, the filler material and Tec Products Yorkshire any coatings on the base metal. Fume rises from the arc and, without adequate control, can build up in the breathing zone of anyone working nearby, which is why extraction is treated as a core part of workshop set-up rather than an optional extra.
Budget for a first machine is rarely just the welder itself. A gas cylinder and regulator for MIG or TIG, a decent auto-darkening helmet, gloves and basic workshop ventilation all add to the real cost of getting started, and skimping on the supporting equipment tends to cost more in frustration than it saves in cash. It's worth pricing the whole set-up before settling on a machine at the top of the budget.