Where the extraction point sits relative to the arc makes a bigger difference than most people expect. A fixed overhead hood can miss fume entirely if the work moves around the shop, whereas a flexible arm or on-torch extraction follows the job and tends to capture more consistently. Filters also need regular checking and tecproducts.co.uk replacement; a clogged filter doesn't just reduce airflow, it can quietly reduce the whole system's effectiveness long before anyone notices.
TIG welding relies on a handful of small consumable parts inside the torch that have an outsized effect on how the arc behaves. The tungsten electrode itself doesn't melt into the weld; it simply carries the arc, and different tungsten types, distinguished by their alloying elements, suit different current types and materials. Getting the wrong tungsten for the job typically shows up as arc wander or poor arc starts long before it shows up anywhere else.
Before choosing a machine, it's worth checking what your workshop's consumer unit and incoming supply can actually handle, not just what socket is nearest the bench. Buying a three-phase-only machine for a single-phase workshop, or underestimating the load a higher-output single-phase welder places on existing wiring, are both avoidable problems with a bit of checking upfront.
Flap discs sit between cutting and grinding in terms of use, combining overlapping abrasive flaps to blend welds, remove coatings and finish surfaces with more control than a solid grinding disc. Every disc also carries a maximum operating speed printed on it by the manufacturer, and checking this against your angle grinder's rated speed is a basic habit worth building into every new batch you open.
The figure changes with output. Turn the amperage down and the duty cycle climbs, because the internal components are working less hard. This is why a welder can feel completely different in a busy production environment compared with occasional home workshop use: someone welding continuously through a shift needs a much higher duty cycle at their working amperage than someone doing short repair jobs a few times a week. It's the kind of spec worth comparing properly across brands such as Kemppi and EWM, not just reading off the headline amperage figure.
Plasma cutting uses a jet of ionised gas, usually compressed air, forced through a nozzle at high speed and heated by an electric arc to a temperature hot enough to melt through electrically conductive metal. The molten material is then blown clear by the same jet, leaving a narrow, clean cut. Unlike oxy-fuel cutting, plasma works on any conductive metal, including stainless steel and aluminium, not just carbon steel. Hypertherm is the plasma cutting brand we get asked about most, and it's worth understanding the basics before comparing specific units.